All MachMotion CNC controls use the Mach3 software. Use the M-code list below as a reference.
Custom |
Functions |
| M200 | Output 5 on |
| M201 | Output 5 off |
| M202 | Output 6 on |
| M203 | Output 6 off |
| M204 | Output 7 on |
| M205 | Output 7 off |
| M206 | Output 8 on |
| M207 | Output 8 off |
| M208 | Output 9 on |
| M209 | Output 9 off |
| M210 | Output 10 on |
| M211 | Output 10 off |
| M212 | Output 11 on |
| M213 | Output 11 off |
| M214 | Output 12 on |
| M215 | Output 12 off |
*These custom M-codes are used to control the relay outputs on the breakout board. Outputs 5-12 must be enabled with the port set to 2 and the pin set to the corresponding relay on the breakout board (R4 = pin 4).
| A | A axis of machine |
| B | B axis of machine |
| C | C axis of machine |
| D | Tool radius compensation number |
| F | Feedrate |
| G | See G-codes table |
| H | Tool lenght offset index |
| I | X axis offset for arc |
| X offset in G87 canned cycle | |
| J | Y axis offset for arcs |
| Y offset in G87 canned cycle | |
| K | Z axis offset for arcs |
| Z offset in G87 canned cycle | |
| L | Number or repetitions in canned cycles/subroutines |
| L1/L2: tool offset settings / fixture offset (with G10) | |
| M | See M-codes |
| N | Line number |
| O | Subroutine label number |
| P | Dwell time in a canned cycle |
| Dwell time with G4 | |
| Tool / Fixture number (with G10) | |
| Tool radius (with G41 / G42 | |
| Q | Feed increment in G83 canned cycle |
| Repetitions of subroutine call | |
| R | Arc radius |
| Canned cycle retract level | |
| S | Spindle speed |
| T | Tool selection |
| X | X axis of machine |
| Y | Y axis of machine |
| Z | Z axis of machine |